I am hungry for some tunes. I was considering where I should place the antenna for the radio on the CitiCar. I’ve looked over quite a few videos and images. There are a few main places that the radio antenna is often placed:
- Standing vertical next to passenger right headlight
- Standing vertical next to passenger lower right window
- Standing 45 degrees along passenger window
- Standing vertical next to drivers left headlight (rare)
I liked the quirkiness of the placement next to the passenger headlight. I had a few concerns about how well a tall classic antenna would be supported against a plastic body and ran it past a few CitiCar and Comuta-Car owners.
It seemed there was a variety of antenna placements among us C-Car owners. One of the owners mentioned that the body should have a dimple for where the antenna should be installed. Curious, I took a closer inspection and there it was – a dimple. Hardly noticeable unless you look for it.
It seemed like a weak spot compared to how ridged the plastic would be around the headlight. Intrigued, I went ahead and took a look at the underside of the body. Much to my satisfaction, I found that the manufacturer installed an aluminum plate specifically for this reason. It had a hole punched out, and I could faintly see the underside of the dimple in the center. The drivers side of the frame did not have a plate.
I started to get to work making a hole. This is old plastic. To prevent cracking, or tearing up the plastic, I started off with a small drill bit, and worked my way up in size.
Finally, the hole was large enough for the threads to poke through. This is where I started to run into problems.
I purchased a classic car radio antenna. It seemed to support going up to a 45 degree angle. I was having a tough time getting it to go through far enough to start getting the nut onto the top. I removed the rubber grommet, but I shill had trouble. I flipped the metal supports upside down to help pull the threads higher.
I found that I wasn’t able to set the antenna up to a full 45 degree angle because there was some plastic at the last part acting as a guide. It took awhile, but I was able to nibble away most of the excess plastic. I was able to get much closer to threading the nut onto the shaft.
I was in a quandary. I decided it was time to take a bit more drastic measures. I picked up a set of vice grips and started bending the nubs on the top of the antennas base. It may not be much – but it’s something.
Something… but it just wasn’t enough.
I took a breather and considered my next stop. Rather than using an antenna that is fixed vertically on a 45 degree base, I started looking for antennas that could be adjusted at any angle. I found one online and put in a new order.
For now, there is the hole.
Looking at me.
One of the C-Car owners recommended a side mount antenna he had used from a Volkswagen Beetle. An order has been placed for one of those antennas as well.